Planar PL1911MW manual Important Safety Instructions

Page 4

Important Safety Instructions

Please read the following instructions carefully. This manual should be retained for future use.

1.To clean LCD Monitor screen;

--Power off LCD Monitor and unplug the AC Cord.

--Spray a non-solvent cleaning solution onto a rag.

--Gently clean the screen with dampened rag.

2.Do not place the LCD Monitor near a window. Exposing the monitor to rain water, moisture or sunlight can severely damage it.

3.Do not apply pressure to the LCD screen. Excess pressure may cause permanent damage to the display.

4.Do not remove the cover or attempt to service this unit by yourself. Servicing of any nature should be performed by an authorized technician.

5.Store LCD Monitor in a room with a room temperature of -20° ~ 60°C (or -4° ~ 140°F). Storing the LCD Monitor outside this range could result in permanent damage.

6.If any of the following occurs, immediately unplug your monitor and call an authorized technician. * Monitor to PC signal cable is frayed or damaged.

* Liquid spilled into LCD Monitor or the monitor has been exposed to rain. * LCD Monitor or the case is damaged.

7.Only use the supplied main lead to connect the monitor. For a nominal current up to 6A and a device weight above 3 kg, a line not lighter than H05VV-F, 3G, 0.75 mm2 must be used.

Important Recycle Instruction:

LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE

RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. FOR MORE INFORMATION, CONTACT THE ELECTRONIC INDUSTRIES ALLIANCE AT WWW.EIAE.ORG. FOR LAMP SPECIFIC DISPOSAL INFORMATION CHECK WWW.LAMPRECYCLE.ORG.

Contains Mercury, Dispose of Properly

3

Image 4
Contents Page Contents Preface FCC Statement WarningImportant Safety Instructions Installation UnpackingConnecting the LCD Monitor Base Optional Mounting AlternativesTilt, Swivel and Pivot Rotation Detaching LCD Monitor from Its StandConnecting the Display Connecting the AC PowerConnecting the Audio Cable Setting Up the LCD MonitorDisplay Controls User ControlsAdjusting the Monitors Display Main OSDSelects input signal to analog D-Sub OSD Lock Out Function Repeat this step to unlock Specifications Technical InformationPlug & Play Standard Timing Table Sync TOTAL/ Active Front Back Pixel Timing NameVESA-768-75Hz Display and cannot be expanded to full screen Troubleshooting Problem Picture is unclear and unstableProduct Registration and Technical Support