Planar PL2011 manual Interface for Arm Applications, Power Management System

Page 7

Optional Mounting Alternatives

Warning: The monitor stand base may forcefully extend and cause injury. Raise the monitor to its "Full Up" position before removing the monitor stand.

Detaching LCD Monitor from Its Stand

Unscrew screws n the swivel base support column and pull downo the second.

Figure 1-3

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997).

Note :Please using Ø 4mm x 8mm (L) screw for this application.

Figure 1-4

Power Management System

This LCD Monitor complies with the VESA DPMS (version 1.0) Power Management guidelines. The VESA DPMS provides four power saving modes through detecting a horizontal or vertical sync. signal. When the LCD Monitor is in power saving mode, the monitor screen will be blank and the power LED indicator will light yellow.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents PL2011 Table of Contents FCC Statement Warning PrefaceImportant Safety Instructions Unpacking InstallationConnecting the Audio Cable Height Adjustment StandConnecting the Display to your Computer Connecting the AC PowerInterface for Arm Applications Power Management SystemOSD Function Menu Adjusting the Monitors DisplayDisplay Controls User ControlsIco Function Function Description Function DescriptionTechnical Information SpecificationsPlug & Play MHZ Standard Timing TableProblem Picture is unclear and unstable Troubleshooting
Top Page Image Contents