Appendix
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help .
FCC Warning
To assure continued FCC compliance, the user must use the provided grounded power supply cord and the provided shielded video interface cable with bonded ferrite cores. Also, any unauthorized changes or modifications to this TFT LCD would void the user's authority to operate this device.
Power Cord Safety Precautions
Caution: Use a power cable that is properly grounded. Always use the AC cords listed below
for each area: |
|
USA | UL |
Canada | CSA |
Germany | VDE |
Switzerland | SEV |
Britain | BASEC/BS |
Japan | Electric Appliance Control Act |
Use an AC cord in other areas that meets local safety standards.
This device must be operated with the original power supply part number: LSE9901B1250(Mfd. by Li Shin), UP06031120A(Mfd. by Potrans).
15