Phantom Tech instruction sheet TOP-ACCESS Insert Trim, Wire, Install Projector and Cradle

INSTRUCTION SHEET

TA SERIES

TOP-ACCESS

5. INSERT TRIM

Once you have cut your opening, remove the heat shield temporarily to install your elongated trim into opening. Pull the elongated trim back up to ceiling and bend the flanges down for a tight fit against ceiling. Staple flanges to sheet rock to secure. Install glare shield if desired. Replace the heat shield back into position.

7. WIRE IN

Remove metal cover from junction box and inspect wiring compartment. Install strain relief device(s) and bring SUPPLY WIRES into junction box. Allow adequate slack in wire(s) to pull J-BOX into housing for servicing transformer. Connect

WHITE transformer and thermal protector lead to neutral supply lead. Connect BLACK thermal protector lead to HOT (120V) supply lead. Connect GREEN fixture wire to supply ground lead. Place all electrical connections in J-BOX and close the J-BOX cover. (See wiring diagram on bottom of page)

6. INSTALL PROJECTOR AND CRADLE

Lower your projector cone into opening and position the projector back at the desired angle. The cradle fits over the projector to hold it into place. Install the projector into the cradle with the three holes on the projector facing up and secure using one black knob to the center hole. Insert pivot pegs into pivot holes on cradle. This is your aiming angle pivot. Angle projector to correct position and tighten the 2 black knobs on sides of cradle. See projector supplement sheet for further instructions regarding lens combinations and projector set up.

Pivot Pegs

DIMMING NOTES This fixture contains an electronic transformer that may require the use of a special dimmer.

LAMPING AND TRANSFORMER NOTES

Socket manufacturers have suggested that sockets may fail after 3 to 6 lamp changes. If this occurs the socket can be replaced by disconnecting the fixture lead wires and replacing it with a new socket procured through PHANTOM™ LIGHTING. In the event of a short circuit or overload, the transformer will automatically shut down the output. The transformer will automatically reset as soon as the short is corrected.

			SUPPLY 120V	TRANSFORMER REPLACEMENT
		WHITE
				1.	Make sure power is off.
		GROUND WIRE
				2.	Remove ceiling trim, projector and mounting cradle.
		12 VOLT	STRAIN RELIEF
			DEVICE	3.	Remove junction box and disconnect supply wires.
		RED
		LEADS	BLACK	4.	Remove transformer from junction box and replace.
			BLUE	5.	Splice transformer red leads to white socket leads.
				6.	Splice transformer black lead to thermal protector blue lead.
		BLACK
		WHITE	PROTECTOR	7.	Splice transformer and thermal protector white leads to supply common leads.
		75 WATT		8.	Splice thermal protector black lead to supply black lead.
			THERMAL	9.	Replace junction box cover.
	WHITE	ELECTRONIC
		TRANSFORMER		10. Reinstall projector mounting cradle, projector and ceiling trim.
	R				ILLUMINATIONS		607 Durham Drive
		ETL LISTED, LUMINAIRES TO UL STD 1598					Houston, Texas 77007-5316
					L i g h t i n g	D e s i g n
C	US & TRACK LIGHTING TO UL STD 1574						Tel: 713-863-1133 / Fax: 713-863-0044

73355