EN
THE ALARM FUNCTION
DISPLAYING THE ALARM TIME
By default, the second line of the unit's LCD screen displays current month and date. To display the alarm time instead, press 
once. To show the month and date again, press MODE.
SETTING / ACTIVATING THE ALARM TIME
1. Press and hold 
for 2 seconds. The alarm hour will flash.
2. Use 
or 
to set the hour. To choose the setting more quickly, press and hold 
or 
continuously.
3. Press 
to confirm and save the desired hour setting. The minutes will automatically flash.
4.Repeat steps 2 and 3 to set the minutes setting. The alarm time has now been set and is automatically
activated. The alarm bell icon 
appears to the left of the alarm time.
5. To deactivate the alarm, press the 
. The LCD no longer displays 
.
NOTE The alarm will automatically stop ringing after 2 minute. But after 8 minutes, the alarm will sound once more unless 
is pressed.
THE SNOOZE FUNCTION
While the alarm is ringing, press the SNOOZE / LIGHT to stop the alarm sound and activate the Snooze function.
When the Snooze function is enabled, the Snooze period will last 8 minutes before the alarm sounds again. 
will flash coninuously on the LCD.
NOTE Pressing SNOOZE / LIGHT turns on the green LED backlight that lasts for 5 seconds before automatically turning off. The backlight does not turn on when any of the other buttons are pressed.
NOTE The Snooze function will disable if the 
button is pressed. The alarm time will remain activated and will ring the following day at the same time unless you press 
again to turn off the alarm.
THE PROJECTOR FUNCTION
The projector displays the time via a bright red projection light onto a wall, ceiling, or just about any surface for easy and convenient viewing in a darkened room. The time projected is shown as a single line (HH:MM) in
1.To activate the projection light, press SNOOZE / LIGHT. The projector will project the time for 5 seconds before automatically turning off.
2.To activate continuous projection, slide the PROJECTION ON / OFF switch to ON. Note that this function will not work unless the AC/DC adaptor is used.
3.To deactivate continuous projection, slide the PROJECTION ON switch to OFF.
6