Oregon Scientific RMR602A user manual Clock, Data Transmission, Search for Sensor

EN

DATA TRANSMISSION

Data is sent from the sensor(s) every 78 seconds. The reception icon shown in the Outdoor Temperature Area shows the status.

ICON	DESCRIPTION
	Main unit is searching for
	sensor.
	Sensor signal is steady.
--- shows	The sensor cannot be
	found. Search for the
	sensor or check batteries.

SEARCH FOR SENSOR

To search for the sensor, press SEARCH . The SEARCH button is located in the main unit battery compartment.

NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location.

NOTE Signals from household devices such as doorbells, electronic garage doors, and home security systems may cause temporary reception failure. This is normal and does not affect general product performance. The reception will resume once the interference ends.

8

CLOCK

This product has two displays: Clock with day of week in German, English, French, Italian, or Spanish, and Calendar display with month and date. The time is automatically updated by the US Atomic Clock in Boulder, Colorado unless you disable this feature. Signals are collected by the main unit when it is within 1500 km (932 miles) of a signal.

Initial reception takes 2 - 10 minutes, and is initiated when you first setup the unit, and whenever you press RESET. Once complete, the reception icon will stop blinking. The icon is shown in the Clock Area.

To force a manual search for Atomic Clock signals, press and hold UP for 2 seconds. If no signal is found, check the batteries.

NOTE If the Atomic Clock signal is received and the hour is incorrect, use the "hour offset" feature to adjust it to to the right value. Please see "SET CLOCK" on pg. 9 for instructions.

RMR602A lab test R2 8 1/17/04, 4:49 PM