Onkyo TX-SR502E, TX-SR8250 Supplied Accessories, Precautions, FCC Information for User

Page 4

TX-SR502_En.book Page 4 Friday, March 12, 2004 1:05 PM

Precautions—Continued

For U.S. models

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in partic- ular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inter- ference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit dif- ferent from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV tech- nician for help.

For Canadian Models

NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLEC- TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRE- SPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

4

Supplied Accessories

Make sure you have the following accessories:

Remote controller & two batteries (AA/R6)

Indoor FM antenna

AM loop antenna

Power-plug adapter

Only supplied in certain countries. Use this adapter if your AC outlet does not match with the plug on the AV Receiver’s power cord. (Adapter varies from country to country.)

75/300-ohm antenna adapter

(Not supplied with American and European models.)

Front

Left

Front

Left

SP-BZone/ 2

Left

SP-BZone/ 2

Left

Front

Right

Front

Right

SP-BZone/ 2

Right

SP-BZone/ 2

Right

Surround

Left

Surround

Left

Surround

Right

Surround

Right

Center

Center

SurroundBack

Left

SurroundBack

Left

Zone2

Left

Zone2

Left

SurroundBack

Right

SurroundBack

Right

Zone2

Right

Zone2

Right

Front

Left

Front

Left

SP-B / Zone 2

Left

SP-B / Zone 2

Left

Front

Right

Front

Right

SP-B / Zone 2

Right

SP-B / Zone 2

Right

Surround

Left

Surround

Left

Surround

Right

Surround

Right

Center

Center

Surround Back

Left

Surround Back

Left

Zone 2

Left

Zone 2

Left

Surround Back

Right

Surround Back

Right

Zone 2

Right

Zone 2

Right

1

2

3

Speaker Cable

Speaker cable labels

*In catalogs and on packaging, the letter added to the end of the product name indicates the color of the AV Receiver. Specifications and operation are the same regardless of color.

Image 4
Contents TX-SR502 TX-SR502E TX-SR8250 Important Safety Instructions AvisPower PrecautionsIf in any doubt, consult a qualified electrician Precautions Supplied AccessoriesFCC Information for User Features Table of ContentsFront & Rear Panels Front PanelDisplay Front & Rear PanelsVideo 3 Input Rear Panel Front Speakers BAC Outlet Subwoofer PRE OUTInstalling the Batteries Before Using the AV ReceiverUsing the Remote Controller Remote Controller How to Use the Remote ControllerAMP/TUNER Mode AMP TunerRemote Controller DVD Mode DVDCD Mode Tape MD Mode & CDR ModeCDR Tape Mode TV Control ButtonsTV Input TV CHEnjoying Home Theater Connecting Your SpeakersSpeaker Configuration Connecting Your Speakers Connecting Your SpeakersConnecting the Speaker Cables Attaching the Speaker LabelsConnecting Antenna Connecting AntennaConnecting the Indoor FM Antenna Connecting the AM Loop AntennaConnecting an Outdoor FM Antenna Connecting AntennaConnecting an Outdoor AM Antenna Connecting the AV Receiver Before Making Any ConnectionsAV Cables & Sockets Optical Digital InputsConnecting the AV Receiver Connection GuideWhich Connections Should I Use? Video Connection FormatsConnecting Your TV or Projector Monitor Out Audio ConnectionsConnecting a DVD player Video ConnectionsYour TV must also be connected via component video DVD playerDVD Multichannel Connection Connecting a VCR for PlaybackVCR Connecting a D-VHS VCR for Playback Connecting a VCR for RecordingUse an optical digital audio cable to connect the AV Output on your D-VHS VCR, as shownSatellite, cable, set-top box LD player, etc Connecting a Camcorder, Games Console, etc CamcorderGames console, etc Other Camcorder, games console, etcConnecting a CD Player Connecting a Cassette Recorder Cassette recorderCD player CD player DAT, CD, or MiniDisc recorderConnecting a Turntable Using a Coaxial or Optical Connection playback onlyTurntable without a Built-in Phono Preamp Turntable with an MC Moving Coil CartridgeConnecting the Power Cords of Other Components Connecting Onkyo ComponentsConnecting the Power Cord Turning On First Time Setup First Time Setup Speaker ConfigurationChanging the TAPE/MD/CDR Display Press the Tape input selectorButton so that Tape appears On the displayPlaying Your AV Components Selecting the Source ComponentUsing the Multichannel Input Playing Your AV ComponentsDisplaying Source Information By the Multi CH button so thatUsing the Tuner Tuning into Radio StationsSetting the AM Tuning Interval Worldwide model only Listening to the RadioUsing the Tuner Presetting Radio StationsSelecting Preset Stations Deleting PresetsAdjusting the Bass & Treble Setting the Display BrightnessCommon Functions Using the Sleep Timer Adjusting Speaker Levels TemporarilyUsing Headphones Common FunctionsUsing the Listening Modes DTS-ESUsing the Listening Modes Selecting with the Remote ControllerSelecting Listening Modes Selecting on the AV ReceiverUse this mode with video games that feature stereo sound About the Listing ModesBasic Modes Surround ModesOnkyo Original DSP Modes Listening mode indicatorsDTS-ES Dolby Digital/DTS setting 5.1 or 6.1-channel playback Recording the Input Source RecordingRecording from Different AV Sources Adjusting the DTS Neo6 Music Mode Using the Audio Adjust FunctionsAdvanced Function Adjusting the PL II or PL IIx Music Mode Digital Input Signal FormatsAdvanced Function Crossover Frequency Advanced SetupSpeaker Distance Advanced Setup Speaker LevelsEntering Remote Control Codes Resetting the DVD, CD, MD or CDR Mode ButtonResetting the Remote Controller Controlling Other ComponentsRemote Control Codes Controlling Other ComponentsDVD DVD player SAT satellite receiverCBL cable receiver ABCTX-SR502En.book Page 53 Friday, March 12, 2004 105 PM TX-SR502En.book Page 54 Friday, March 12, 2004 105 PM Controlling a TV Controlling a Cable ReceiverControlling a VCR Controlling a Satellite ReceiverTroubleshooting Troubleshooting TV?Tuner Recording Others Symptom Possible cause Remedy REO indicator flashes?Signals? Tuner presets noSpecifications Amplifier SectionGeneral Video SectionOnkyo Europe Electronics GmbH Onkyo U.S.A. CorporationOnkyo China Limited
Related manuals
Manual 60 pages 54.45 Kb