Appendices
Replacing the Lamp
The projector keeps track of the lamp usage. It will show you a warning message
Warning: Lamp compartment is hot! Allow 30 minutes to cool down before changing lamp!
When you see this message, change the lamp as soon as pos- sible. Make sure the projector has cooled down for at least 30 minutes before changing the lamp.
3 |
1
2 | 4 |
Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped.
Lamp Replacement Procedure:
1.Switch off the power to the projector by pressing the Power/
Standby button.
2.Allow the projector to cool down for at least 30 minutes.
3.Disconnect the power cord.
4.Use a screwdriver to remove the screws from the cover.
5.Push up and remove the cover.
6.Remove the 2 screws from the lamp module.
7.Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
English 34