Optoma Technology TX6353D, TW6353D manual Automatic, Phase, Frequency, Position

Page 37

User Controls

SETUP Signal (RGB)

“Signal” is only supported in Analog VGA (RGB) signal.

Automatic

Automatically selects the signal. If you use this function, the Phase, frequency items are grayed out, and if Signal is not auto- matic, the phase, frequency items will appear for user to manually tune and saved in settings after that for next time projector turns

off and on again.

Phase

Synchronize the signal timing of the display with the graphic card. If the image appears to be unstable or flickers, use this function to correct it.

Frequency

Change the display data frequency to match the frequency of your computer’s graphic card. Use this function only if the image appears to flicker vertically.

H. Position

Press the to move the image left.

Press the to move the image right.

V. Position

Press the to move the image down.

Press the to move the image up.

37English

Image 37
Contents Table of Contents Usage Notice Safety InformationPrecautions Do not Product Features Eye Safety WarningsPackage Overview IntroductionMain Unit Product OverviewControl Panel Input/Output Connections Remote Control Connect to Computer/Notebook Connecting the ProjectorConnect to Video Sources Powering On the Projector Powering the projector On / OffPowering off the projector Adjusting the Projector’s Height Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector’s Zoom / FocusSVGA/XGA User Controls Control Panel & Remote ControlUsing the Remote Control Press Freeze to pause the screen image Using the Help button User Controls User Controls On-screen Display Menus How to operateImage Menu TreeOptions Brightness Display ModeContrast Color SharpnessTint Gamma Color SettingsBrilliantColor Color TempInput Source Color SpaceFormat DisplayLBX Zoom Edge MaskImage Shift Keystone3D Sync. Invert 3D ModeProjection LanguageMenu Location VolumeScreen Type Projector IDAutomatic PhaseFrequency PositionChange Password Security TimerSecurity User Controls Logo Capture LogoClosed Captioning IP Address Network StateSubnet Mask GatewayHow to use web browser to control your projector Below is an example on how to do a quick network setup Crestron RoomView Control Tool For more information, please visit Source Lock ResetHigh Altitude Information HideAuto Power Off min Direct Power OnSleep Timer min Power Mode StandbyLamp Reset Brightness ModeLamp Hours Lamp ReminderNetwork Application System Introduction How to use Web AdministrationSystem Status General SetupNetwork Setup Alert SetupProjector Control Presenter Setup Crestron RoomView Click Tools, the following items are included Reboot System Reset to DefaultHow to use Multi-media Card Reader Application Slideshow Controls Center of the screen How to use the Optoma Presenter System Power on projector Alterable size mode The frame in Alterable mode can be en Display range Change the display port Appendices TroubleshootingImage is unstable or flickering Image is reversed Projector stops responding to all controls On Screen Messages Replacing the lamp Lamp Replacement Procedure  Computer Compatibility Compatibility ModesSvga XGA Wxga  Video Compatibility Mode Resolution Sync Hz Sync KHzRS232 Pin Assignments RS232 Commands and Protocol Function ListAscii Code HEX CodeFunctionDescription RS232 Protocol Function ListLBX Send to emulate Remote Ascii Code HEX CodeFunctionProjector Return Description Wall Mount Installation USA Optoma Global OfficesBenelux BV FCC notice Regulation & Safety NoticesRemarque à l’intention des utilisateurs canadiens