Onkyo Comprehensive Guide to Setting Up Your TX-SR304 Receiver

First Time Setup—Continued

5	Use the Down [	] button to
	select “Center,” and then use the
	Left and Right [	]/[ ] buttons to
	select Small, Large, or None.

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

	Note:
	• If the Front setting in step 4 is set to
	Small, the Large option cannot be
	selected.
6	Use the Down [ ] button to
	select “Surround,” and then use
	the Left and Right [ ]/[ ] but-
	tons to select Small, Large, or
	None.
	Small: Select if the surround speak-
	ers are small.
	Large: Select if the surround speak-
	ers are large.
	None: Select if no surround speakers
	are connected.
	Note:
	• If the Front setting in step 4 is set to
	Small, the Large option cannot be
	selected.
7	Press the [SETUP] button.
	Setup closes.
	When you want to go back up one
SETUP	menu level to “SP Config,” press the
	[RETURN] button.

Testing the speakers

To test that all of the speakers are working properly,

press the remote controller’s [TEST TONE] but- ton.

		LISTENING MODE
	STEREO	SURROUND
	AUDIO	SUBTITLE RANDOM		REPEAT
TEST TONE	TEST TONE	CH SEL	LEVEL-	LEVEL+
		PLAY MODE
	DISPLAY		L NIGHT	CINE FLTR
		RC-645S

The test tone will be output by each speaker in turn and the name of each speaker will appear on the dis- play. To turn off the test tone, press the [TEST TONE] button again.

•If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display, you may have wired the speakers incorrectly and you should check your connec- tions (see pages 18, 19).

•If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the speaker settings incorrectly (see page 34).

35