Optoma Technology TX610ST manual Regulation & Safety Notices, FCC notice

Page 65

Appendices

Regulation & Safety Notices

This appendix lists the general notices of your projector.

FCC notice

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this projector.

65English

Image 65
Contents Table of Contents Usage Notice Safety InformationPrecautions Do not Product Features Eye Safety WarningsPackage Overview IntroductionMain Unit Product OverviewControl Panel 12V OUT Input/Output ConnectionsRemote Control Connect to Computer/Notebook Connecting the ProjectorComposite Video Output +12V Output Connect to Video SourcesPowering On the Projector Powering the projector On / OffPowering off the projector Adjusting the Projector’s Height Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector’s FocusXGA User Controls Control Panel & Remote ControlUsing the Remote Control VGA Using the Help button User Controls User Controls On-screen Display Menus How to operateImage Menu TreeOptions Contrast Display ModeBrightness Tint SharpnessSaturation BrilliantColor DegammaColor Temp ColorImage AI Color SpaceInput Source Format DisplayLBX Zoom OverscanImage Shift Keystone3D Sync. Invert Display 3DProjection LanguageScreen Type Menu LocationProjector ID MuteRS232 VolumeAudio Input Automatic PhaseFrequency PositionSecurity Security TimerChange Password User Controls Closed Captioning LogoLogo Capture IP Address Network StateSubnet Mask GatewayHow to use web browser to control your projector Local Area Network LAN Source Lock ResetHigh Altitude Information HideAuto Power Off min Direct Power OnSleep Timer min Power Mode StandbyLamp Reset Brightness ModeLamp Hours Lamp ReminderAppendices TroubleshootingImage is unstable or flickering Image is reversed Projector stops responding to all controls On Screen Messages Replacing the lamp Lamp Replacement Procedure  Computer Compatibility Compatibility Modes Video Compatibility Mode Resolution Sync Hz Sync KHzRS232 Pin Assignments RS232 Commands and Protocol Function ListSend to projector RS232 Protocol Function ListVGA1 Send to emulate Remote Send from projector automatically Ceiling Mount Installation USA Optoma Global OfficesLatin America FCC notice Regulation & Safety NoticesRemarque à l’intention des utilisateurs canadiens
Related manuals
Manual 2 pages 11.44 Kb