Installation
When Power mode (Standby) is set to Eco (<0.5W), the
VGA output and Audio
will be deactivated when the projector is in standby.
Powering On/Off the Projector
Powering On the Projector
1.Remove the lens cap.
2.Securely connect the power cord and signal cable. When connected, the ON/STANDBY LED will turn Amber.
3.Turn on the lamp by pressing “” button either on the top of the projector or on the remote. The ON/STANDBY LED will now turn Green.
The startup screen will display in approximately 10 seconds. The first time you use the projector, you will be asked to select the preferred language and power saving mode.
4.Turn on and connect the source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically. If not, push menu button and go to “OPTIONS”.
Make sure that the “Source Lock” has been set to “Off”.
If you connect multiple sources at the same time, press the “SOURCE” button on the control panel or direct source keys on the remote control to switch between inputs.
2 Power
Turn on the projec- tor first and then select the signal sources.
1 Lens Cap
English 18