Optoma Technology EW1610 manual Regulation & Safety notices

Page 58

Appendices

Regulation & Safety notices

This appendix lists the general notices of your projector.

FCC notice

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Change or modification not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this projector.

English 58

Image 58
Contents Table of Contents Safety Informations Usage NoticePrecautions Don’t Eye Safety Warnings Introduction Projector with lens cap Power Cord 1.8m Package OverviewProduct Overview Main UnitControl Panel Connection Ports Remote Control Installation Connecting the ProjectorConnect to Video Sources Powering On/Off the Projector Powering On the ProjectorPowering off the projector Adjusting the Projected Image Adjusting the Projector’s HeightAdjusting the Projector’s Zoom / Focus Adjusting Projection Image SizeControl Panel & Remote Control User ControlsRemote Control Power Remote Control How to operate On-screen Display MenusMenu Tree Brightness Display ModeImage ContrastSaturation TintImage Color ResetColor White Peaking Image AdvancedDegamma Color TempImage AI Input Source Display FormatInput Signal Image Shift OverscanZoom KeystonePC Mode Setup Language LanguageProjector ID SetupProjection Information HideStart Up Logo Screen TypeSecurity Timer Setup SecuritySecurity Change Password First TimeFrequency Setup SignalPhase PositionOptions Volume Sleep Timer min Direct Power OnAuto Power Off min Options AdvancedLamp Reset Options Lamp SettingsBrightness Mode Lamp HoursTroubleshooting Image ProblemsImage is unstable or flickering Image is reversed Intermission Problems Projector Status IndicationMessage Reminders Remote Control Problems If the remote control does not workReplacing the lamp Lamp Replacement Procedure  Computer Compatibility Compatibility Modes Video Compatibility RS232 Commands RS232 Commands RS232 Protocol Function ListSend from projector automatically Ceiling Mount Installation Optoma Global Offices Korean Regulation & Safety notices Remarque à l’intention des utilisateurs canadiens