Settings menu
Sources: allows you to assign a particular input to a specific source key on the remote and enables or disables Autosource. When Autosource is not checked, the projector defaults to the
You can use the Source Enable feature to eliminate certain sources from this search, which will speed the search. By default, the check boxes for all sources are checked. Uncheck a source’s box to eliminate it from the search.
System
All options in this menu toggle between on and off.
Rear: reverses the image so you can project from behind a translucent screen.
Ceiling: turns the image upside down for
NOTE: It is recommended that all final image adjustments in Ceiling mode are made once the unit has fully warmed up (approximately 20 minutes).
Auto Power: When Auto Power is checked, the projector automatically goes into the startup state after the projector receives power. This allows control of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as “Searching”) in the
High Power: Turn this on to increase the light output of the lamp. This also shortens lamp life and increases fan noise.
Settings menu | Sources |
Source 1 | Source Enable |
|
System menu
27