Marantz RX8001 manual Configuring the Extender, Stand-alone Connection, Network Connection

Page 7

RX8001 User Guide

Configuring the Extender

Note Before you start configuring the Extender, check for firmware updates in the Downloads section on http://www.marantz.com in the Home Entertainment section of your region.

Refer to the chapter ‘Firmware Update’ on page 9 for further details.

Stand-alone Connection

To configure the Stand-alone Extender:

1Plug in the Extender’s power adapter.

The Extender will start up. When start-up has finished, the Power and WiFi LEDs are green.

2Use the default switch settings of the Extender:

 

 

Stand-alone/Network

Stand-alone

 

 

 

Configuration switch

1

 

 

 

Extender ID

0

 

 

 

 

 

 

 

 

 

 

 

Note • If there is already an Extender with ID 0, set the Extender ID switch to an ID that is not used yet.

If there is any interference with other products in or around the house, the Configuration switch can be set to a different RF channel.

Make sure the same Extender ID and RF channel are used on the Extender and the Control Panel.

3Configure the Control Panel’s configuration file so that the Control Panel can work with the Extender. For more details, refer to the Wizz.it Ex Online Help.

Network Connection

In the case of a network connection, the Extender is made part of the wireless

Network.

There are two ways to use the Extender in a network:

 

 

Wired connection

 

Straight Ethernet Cable

 

 

Extender

 

 

 

 

Control Panel

 

Router

 

 

 

Wireless

 

 

 

Access Point

 

Wireless connection

 

 

 

 

Extender

Control Panel

 

 

 

Wireless

 

 

 

Access Point

 

 

Note When you set up a Wireless Network connection, make sure the Control Panel always shows minimal one bar of WiFi connectivity. If this is not the case, you may need additional Wireless Access points in your network.

ENGLISH

4

Image 7
Contents Model RX8001 User Guide Wireless Extender Avertissements RX8001 UserRX8001 UserGuideGuide RX8001X8001 User GuideUser Guide ContentsStand-alone Advantages Stand-alone ModeNetwork Mode Before You StartUnpacking the Extender Wireless ExtenderStand-alone Connection Configuring the ExtenderNetwork Connection To configure the Network Extender Configuring the Extender through a Router Installing the ExtenderConnecting the Extender to A/V equipment Support TroubleshootingWhat Do the LEDs Indicate? Operating A/V components with the Extender Extender cannot communicate with the wireless networkA/V components do not respond to commands from the Extender Busy LED blinks green when the Control Panel is not in useUpdating the Extender through a router Firmware UpdateResetting the Extender Updating the Extender with the configuration cableWireless Extender User Guide SpecificationsRemarks Regulations According to R&TTE FCC CompliancyDeclaration Declaration of ConformityDoC Marking German Entsorgung Ihres alten Geräts Dutch Verwijdering van uw oude productFinnish Vanhan tuotteen hävittäminen French Mise au rebut des produits en fin de vieSwedish Kassering av din gamla produkt Norwegian Avhending av gamle produkterEliminação do seu antigo produto Spanish Desecho del producto antiguoRX8001 User Guide RX8001 User Guide Is a registered trademark