InFocus IN10 quick start Turn on the projector, Turn on the computer, Show the picture

Page 4

4 Turn on the projector

1 Plug the power cord into the projector and into an electrical outlet

The power light on the projector will light amber.

2 Press the power button

The power light will start blinking green.

3 Wait for the lamp to warm up

After a few seconds, the power light will stop blinking and stay green . It can take a minute for the lamp to reach full

brightness. 5-10 sec.

Warning: Do not look directly into the lens when the projector is turned on.

5

6

Turn on the computer

or other source

Got a laptop? You may need to enable its external video port

On most laptops, hold down the Fn key and press the function key labeled CRT/LCD, LCD/VGA, , or similar.

Apple F7

Gateway Fn+F3 or Fn+F4

ThinkPad Fn+F7

Dell Fn+F8

HP/Compaq Fn+F4 or Fn+F6

Toshiba Fn+F5

Fujitsu Fn+F10

Sony Fn+F7

 

Key combos for more laptops at www.infocus.com/support

Show the picture

If the picture isn’t visible, keep pressing the source/select button until you see it. Wait a few seconds between each press.

i

If there’s still no picture: Restart your computer.

See Troubleshooting for more help.

Image 4
Contents Quick Start Unpack the box ErrorDispose of batteries in an environmentally proper manner Got an Apple computer? USB is optional Available from A/V dealer or retailerPress the power button Turn on the projectorTurn on the computer Show the pictureAdjust the picture HeightKeystone Zoom and focusPress the power button twice Turn off the projectorRegister your product Read the Reference GuideTroubleshooting Signal out of range is shown, or picture looks badNo picture, blank picture, or InFocus is shown Red light is blinking+1 503 Singapore +31 036 539 Toll Free China Questions? We’re here to helpAustralia