InFocus in2100 quick start Turn on projector and source

4 Turn on projector and source

5-10 sec.

source

1	Connect the power cord to the
	projector and to an electrical
	outlet
	The power light		on the projector will light amber.
2	Slide open the lens cover
3	Turn on the projector
	Touch the power light (or press power on the remote).
	The power light will start blinking green.
4	Wait for the lamp to warm up
	After a few seconds, the power light will stop blinking
	and turn green. It can take a minute for the lamp to
	reach full brightness.
	Warning: Do not look directly into the lens while
	! the projector is being used.
5	Turn on computer or other source
	You may need to press a specific key combination to activate
	your laptop’s external video port. On most laptops, hold
	down the FN key while pressing a key labeled CRT/LCD, LCD/
	VGA, a monitor icon		, or similar. Key combos for popular
	models:
	Apple F7	HP/Compaq Fn+F4 or Fn+F6		Sony Fn+F7
	Dell Fn+F8	IBM ThinkPad Fn+F7		Toshiba Fn+F5
	Fujitsu Fn+F10

Complete laptop activation chart at www.infocus.com/support

Important: If there is still no video, restart your i computer (first make sure it’s connected to the

projector and the projector is turned on).

6 Change source if needed

If needed, press source (on the projector or remote) to view the source. You may have to press it more than once.