InFocus IN74, IN76 manual Displaying an image, Adjusting the image

Displaying an image

Connect the power cord to the Power connector on the back of the projector and to your electrical outlet.

NOTE: Always use the power cord that shipped with the projector.

Press the Power button on the remote or keypad.

The LED flashes green and the fans start to run. When the lamp comes on, the start-up screen is displayed and the LED is steady green. It can take a minute for the image to achieve full brightness.

?No start up screen? Get help on page 13. Plug in, connect, and turn on your video device.

The video device’s image should appear on the projection screen. If it doesn’t, press the Source button on the keypad until the image appears.

?No image? Try pressing the Auto Image button on the remote. Get help on page 13.

plug in Power cord

press Power button

turn on video device

Adjusting the image

Adjust the height of the image by tilting the projector up or down.

Position the projector the desired distance from the screen at a 90 degree angle to the screen.

See page 5 for a table listing screen sizes and distances to the screen.

adjust height

adjust distance

10