4 Turn on projector and source
1 Connect the power cord to the projector 
and to an electrical outlet
The power light 
on the projector will light amber.
2
3
Turn on the projector
Press power (on the projector or remote).
The power light will start blinking green.
Wait for the lamp to warm up
After a few seconds, the power light will stop blinking and turn green. It can take a minute for the lamp to reach full brightness.
Warning: Do not look directly into the lens when the projector is turned on.
4 Turn on computer or other source
You may need to press a specific key combination to activate your laptop's external video port. On most laptops, hold down the FN key while pressing a key labeled CRT/LCD, LCD/VGA, a monitor icon 
, or similar. Key combos for popular models:
Apple F7 | Gateway Fn+F3 or Fn+F4 | IBM ThinkPad Fn+F7 |
Dell Fn+F8 | HP/Compaq Fn+F4 or Fn+F6 | Toshiba Fn+F5 |
Fujitsu Fn+F10 | Sony Fn+F7 |
|
|
|
| Complete laptop activation chart at www.infocus.com/support | |
|
|
| i | Important: If there is still no video, restart your |
source | computer (first make sure it's connected to the | |||
|
|
|
| projector and the projector is turned on). |
5 Change source if needed
If needed, press source (on the projector or remote) to view the source. You may have to press it more than once.