JVC DILA projector Firmware Update Instructions
The Wizard will install the driver and then display a message to confirm that it has completed the installation
*If, for any reason, the driver does not install automatically, you can install it manually. You will find the Driver and .Inf file in the application folder.
When the Wizard has finished installing the driver, click “Finish”.
After a few seconds, if the driver has installed successfully, you will see this confirmation message.
This completes installation of the USB driver and will now allow your PC to communicate with the projector. If you leave the driver installed, you will not have to repeat the above procedure for any future firmware updates that may become available.
The next step is to update the firmware in the projector. This is covered in the following pages.
If you are going to update the firmware immediately after installing the USB driver, you can leave the projector in Download Mode and proceed from the line “Start the
Page 3 of 6