JVC GV-DV1000 manual 10 EN, For Windows

Page 10

10EN

INSTALLINGDV CAPTURE DRIVERS

Caution

•In case the DV Capture Board has been installed with Windows® 95, these steps are not required.

FOR WINDOWS® 98

Before you use the DVC Capture Board, you must install the DV Capture Board drivers. If you have not done so already, install the DV Capture Board (see p. 8). Follow these steps to install the drivers. If you make a mistake during the install procedure, click the Back button and correct the mistake.

1 Turn on your computer. Put the included JVC CD-ROM in your CD-ROM drive. The New Hardware Found Window is displayed.

If the New Hardware Found Window is not displayed click the Start button on the Task Bar and select Shut Down. In the Shut Down Windows window select Restart the computer and click OK.

2 The Add New Hardware Wizard is displayed.

Click the Next button.

3 Make sure Search for the best driver for your device. (Recommended). is

selected. Then click the Next button.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents GV-DV1000 JVC Softwar E License a Gree Ment Limited Warranty Contents Technical Support for Registered User EN TE Chnical Support F or Registe RED User Product Stallin G DV Capture Board Ieee 1394 DV Capture Board 10 EN For WindowsPage 12 EN For Windows 95 Version 4.00.950B or LaterPage 14 EN For Windows 95 Version 4.00.950 or 4.00.950APage Connecting DV Device Connecting a N D Troub Leshooting16 EN Troubleshooting for DV Capture Board For Windows 98 P ~1118 EN PreparationStarting UP Video Navigator Installing P Hotosuite SE 20 ENInstalling Videoworks EN Installing Acrob AT Reader 22 ENStarting UP Videoworks Finishing Videoworks24 EN Importing IM Ages Into VideoworksMemo Tion
Top Page Image Contents