Connecting to Remote Control Unit RM-P210

e_ka250.book Page 12 Tuesday, September 5, 2006 4:10 PM

PREPARATIONS

Connection

Switch off RM-P210 power supply before attempting the con- nection.

3.Connecting a Monitor

Prompter video (RM-P210 [AUX VIDEO INPUT] terminal input signal) from RM-P210 can be verified by connecting this unit’s [PROMPTER OUTPUT] terminal located in the front to a monitor using a BNC cable.

MEMO

•Power for this unit and the camera are supplied by RM- P210 via the 26 pin camera cable.

•26 pin camera cable VC-P110 (5 m) VC-P112 (20 m) VC-P113 (50 m) VC-P114 (100 m)

Menu Screen Setting

1.Output Signal Setting

Composite video signal is always output from the RM multi-pin connector. In addition, RGB component, Y/PB/ PR component or YC separate signal can also be output. Select the output signal using the OUTPUT item on the SYSTEM menu screen

MEMO

Sync signals are superimposed onto RGB component sig- nals.

1.Connecting the RM-G210

Connect this unit’s RM multi-pin connector and RM-P210 using the 26 pin camera cable. Length of the camera cable should not be longer than 100 m.

2.Connecting the DT-109U

Connect the Headset DT-109U plug to the [INTERCOM] terminal to use an intercom headset.

MEMO

This device supports only DYNAMIC-type headset. CAR- BON-type headphones cannot be connected.

Switch Setting

1.Enabling/disabling INCOM MIC

Set the [INCOM MIC ON/OFF] switch depending on whether headset microphone will be used. Set the switch to [ON] use the headset microphone.

INCOM MIC

ON/OFF switch