Seiko Group TM-T90 user manual Power Switch and Power Switch Cover, Unpacking

Page 5

English

PAPER OUT LED

Lights when roll paper is nearly out.

FEED Button

Feeds the roll paper.

Power Switch and Power Switch Cover

The power switch is on the front of the printer. Press it to turn on the printer, and press and hold it for more than 3 seconds to turn off the printer.

Power Switch Cover

You can use the enclosed power switch cover to make sure that the power switch is not accidentally pressed. Peel off the backing tape and press the cover into place to install it in the position shown in the illustration below.

WARNING:

If an accident occurs when the power switch cover is attached, immediately remove the bottom cover and unplug the power supply cable to avoid fire.

Unpacking

The following items are included for the standard specification printer. If any items are damaged, contact your dealer.

Printer

Paper roll

Power switch cover

Control panel label used for vertical installation

Rubber feet (4) for vertical installation

TM-T90 User’s Manual 3

Image 5
Contents TM-T90 Printer Parts DIP Switch TablesEnglish Safety PrecautionsLEDs and Button Restriction of UseControl Panel Unpacking Power Switch and Power Switch CoverPower Switch Cover Downloading Drivers, Utilities, and Manuals Installing Horizontally or VerticallyBe sure to use paper rolls that meet the specifications Installing the Paper RollError LED on or flashing TroubleshootingConnecting Cables Cleaning the Print HeadTM-T90 Specifications TM-T90 安全上のご注意 ご使用の前に安全にお使いいただくために 使用制限 電波障害自主規制について電源スイッチと電源スイッチカバー 注意ラベルコントロールパネル ドライバ、ユーティリティ、マニュアル類のダウンロード 同梱品水平設置および縦置き設置 ロール紙の挿入トラブルシューティング Error LED 点灯 / 点滅ディップスイッチ ケーブルの接続16 TM-T90ユーザーズマニュアル 中文(简体) 安全注意事项 DIP 开关表注意事项的标记 控制面板 下载驱动程序、应用程序以及操作说明 水平或垂直安装 清洁打印头 TM-T90 规格表 Page 中文(繁體) 安全注意事項 DIP 開關表注意事項的標籤 控制面板 故障排除 下載驅動程序、應用程序以及操作說明 水平或垂直安裝安裝紙筒 連接連接線 清潔列印頭TM-T90 規格表 English Weee Waste Electrical and Electronic Equipment DirectiveČesky 2001.02