Sharp EL-9450 Creating an Original Slide Show, Viewing the Original Slide Show, Setup menu

SLIDE SHOW FUNCTION

To enter the slide show screen, press	.
The main menu of the slide show has the following classifications.
A B-IN .... Used to call up the built-in slide show screen.
B ORG ... Used to call up the original slide show screen.
C NEW ... Used to perform the default settings
(registration of name) for the original slide screen.
D EDIT ... Used to edit the original slide show.		Main	menu
				Sub-menu

1. Creating an Original Slide Show

The calculator provides a function which allows you to create your own slide show screens and register them.

•The number of screens which you can store may vary depending on the amount of free memory. (It is possible to register as many screens as the memory capacity allows. However, if you use up most of the memory for the slide show, this may affect other calculations.)

•A title can be put on the original slide show. (Only one title can be put on the slide show.)

•The flowchart for creating your original slide show is shown below.

Enter the slide show creation mode. : C

Put a title on the slide show.		: Input a title.®
		: After creating an original slide show, press Ï	to store
	Register screens.
		the original slide show.

•The original slide show has no specific end mark. (When another slide show is created following the original slide show, the previous data is cleared and updated by the new slide show.)

<Example>

Input “Y1 = 2X–5” and “Y2 = X2”, and then store the equations, graph screen, table screen, and graph and table screen in sequential order. (Set to the X-Y coordinate system.)

1.Press ¬.

2.Press C®.

Selects the original slide show (new slide show) creation mode.

3.lnput the title as “GRAPH”. (Up to 8 characters can be used for the title.)

Press ®.

4.Press and enter “2X–5” to Y1 and “X2” to Y2.

5.Press Ï.

The message, “STORE SCREEN:01”, will appear instantaneously.

6.Press .

Draws graphs for “Y1 = 2X – 5” and “Y2 = X2”.

7.Press Ï.

The message, “STORE SCREEN:02”, will appear instantaneously.

Repeat the above steps to register the necessary screens.

Subsequently, normal operations can be performed unless Ïand are pressed.

If an original Slide Show has been already stored, the delete confirmation display appears after selecting [C NEW].

Press ®to delete the previous Slide Show file.

Press Ïœto cancel.

2. Viewing the Original Slide Show

To view the original slide show which was created previously, follow these steps.

1.Press B. Sets the slide show to the view mode.

2.Press ®. (The symbol, “01” is highlighted in the upper right corner of the screen.)

3.Press ≥ or ≤ to navigate the screen.

3.Editing the Original Slide Show

The registered slide show data can be sorted, and deleted, and the title can be renamed in the edit mode.

(1)Changing the order of the screens (MOVE)

1.Press D1.

2.Press ≥ or ≤ to call up the screen you wish to move and press ®.

3.Press ≥ or ≤ to select the place you wish to move to and press ®.

*Exit this mode by pressing Ϝ.

(2)Deleting the registered screen (DEL)

To delete screen.

1.Press D2.

2.Press ≥ or ≤ to select the screen.

3.Press ®to delete.

Renaming the registered title (RENAME)

To change the title.

1.Press D3.

2.Input the new title.

3.Press ®.

Additional Explanation for EL-9450 Menus

EL-9450 functions (P189)

Major-	Sub-	Minor-	Name	Description	Example of use
category	category	category
SETUP	H	1	Auto	Sets to the automatic	Selection in the
	SIMPLE			simplification	menu screen will fix
					the mode.
		2	Manual	Sets to the manual simplification
EL-9450 functions (P191)
Major-	Sub-	Minor-	Name	Description	Example of use
category	category	category
MATH	B NUM	0	remain	Calculate the remainder of	natural number
				integer division integer	remain
				remain integer	natural number

EL-9450 functions (P207)

	Major-	Sub-	Minor-	Name	Description	Example of use
	category	category	category
* PRGM		G S_PLOT	4	PlotON	Sets drawing of the specified	PlotON [number]
	COM				statistical graph to on.
			5	PlotOFF	Sets drawing of the specified	PlotOFF [number]
					statistical graph to off.
	EL-9450 functions (P219-220)
	Major-	Sub-	Minor-	Name	Description	Example of use
	category	category	category
	STAT	E BOX	1	Box	Specifies box plot. The lines	Box
	GRAPH				on either side are drawn the
					length of Q1-Xmin and
					Q3-Xmas
			2	MBox•	Specifies modified box plot.	MBox •
					The lines on either side is
					(Q3–Q1) x 1.5
					Uses “•” to draw data points
					(including Xmin and Xmax)
					of the lines that are on the
					outside
			3	MBox+	Specifies modified box plot.	MBox +
					The lines on either side is
					(Q3–Q1) x 1.5
					Uses “+” to draw data points
					(including Xmin and Xmax)
					of the lines that are on the
					outside
			4	MBox	Specifies modified box plot.	MBox
					The lines on either side is
					(Q3–Q1) x 1.5
					Uses “ ” to draw data points
					(including Xmin and Xmax)
					of the lines that are on the
					outside
	EL-9450 functions (P220)
	Major-	Sub-	Minor-	Name	Description	Example of use
	category	category	category
	STAT	F PIE	1	Pie	Draws a pie graph using	Pie
	GRAPH				entered values.
			2	Pie%	Draws a pie graph using the	Pie%
					percentage
	EL-9450 functions (P223)
	Major-	Sub-	Minor-	Name	Description	Example of use
	category	category	category
	SLIDE	B ORG			Displays the title and the
	SHOW				number of screens of the
					currently editing Slide Show.
		C NEW			Creates a new SLIDE SHOW
					file to store screen images.
		D EDIT	1	MOVE	Move the pages.
			2	DEL	Delete the pages
			3	RENAME	Rename the title of the slide show.

SETUP menu			P 225
	(Same as the EL-9400)
		H SIMPLE
		Auto
MATH menu		Manual
			P 226

(Same as the EL-9400.)

	0 remain
PRGM menu
		P 229

(Same as the EL-9400)

					4 Plot ON
					5 Plot OFF
STAT GRAPH menu
						P 232
	(Same as the EL-9400)
			E BOX	F PIE
		1	Box	Pie
2			M Box	Pie%

3M Box

4M Box

SLIDE SHOW menu
				P 233
	B ORG	C NEW	D EDIT
			MOVE
			DEL
			RENAME

This equipment complies with the requirements of Directive	Ô‰ËÁÈÒÓ Ù˘ ∂˘Úˆ·˚΋˜ ∂ÓˆÛ˘ 89/336/∂√∫, fiˆ˜ Ô
89/336/EEC as amended by 93/68/EEC.	ηÓÔÓÈÛÌfi˜ ·˘Ùfi˜ Û˘ÌÏËÚÒıËΠ·fi ÙËÓ Ô‰ËÁ›· 93/68/
Dieses Gerät entspricht den Anforderungen der EG-Richtlinie	∂√∫.
89/336/EWG mit Änderung 93/68/EWG.	Este equipamento obedece às exigências da directiva 89/
Ce matériel répond aux exigences contenues dans la direc-	336/CEE na sua versão corrigida pela directiva 93/68/CEE.
tive 89/336/CEE modifiée par la directive 93/68/CEE.	Este aparato satisface las exigencias de la Directiva 89/336/
Dit apparaat voldoet aan de eisen van de richtlijn 89/336/	CEE, modificada por medio de la 93/68/CEE.
EEG, gewijzigd door 93/68/EEG.	Denna utrustning uppfyller kraven enligt riktlinjen 89/336/EEC
Dette udstyr overholder kravene i direktiv nr. 89/336/EEC med	så som kompletteras av 93/68/EEC.
tillæg nr. 93/68/EEC.	Dette produktet oppfyller betingelsene i direktivet 89/336/EEC
Quest’apparecchio è conforme ai requisiti della direttiva 89/	i endringen 93/68/EEC.
336/EEC come emendata dalla direttiva 93/68/EEC.	Tämä laite täyttää direktiivin 89/336/EEC vaatimukset, jota
∏ ÂÁηٿÛÙ·ÛË ·˘Ù‹ ·ÓÙ·ÔÎÚ›ÓÂÙ·È ÛÙȘ ··ÈÙ‹ÛÂȘ ÙˆÓ	on muutettu direktiivillä 93/68/EEC.