NAD T 743 owner manual Summary of HTR 2 Modes, Trigger Setup, Assigning the Trigger Output

USING THE HTR 2 REMOTE CONTROL

Search Mode

If none of the codes from the table, when entered, turns on the component, and if you are quite sure you have followed the above procedure completely and carefully, you may want to try the “search” method as follows:

Enter Library Mode by simultaneously pressing-and-holding for 3 seconds both the desired Device Selector key and the [A/V PRESET] key, until the Learn LED turns green. Now press-and-hold the HTR 2’s [ ] (or [ ]) key; the remote will step through all the available codes at a rate of approximately 1 per second. When the component turns off, immediately release the cursor key; press [ENTER] to accept that code-library and exit the Library Mode. Try a few commands; should you prove to have stepped past the needed code-library, re-enter the Library Mode and use the cursor key to step back to it.

NOTE: It is possible that search mode will find code-libraries that operate, at least partially, some other- brand (non-NAD) components. You may certainly exploit such capabilities as you find them. However, since we can only ensure the completeness or accuracy of NAD code-libraries, we cannot support the HTR 2’s operation with other-brand components.

Checking Code-Library Number

You can check the current code-library on any Device Selector key as follows. Enter Library Mode by simultaneously pressing-and-holding for 3 seconds both the desired component’s Device Selector key and the [A/V PRESET] key, until the Learn LED turns green. Press the [DISP] key; the HTR 2 indicates the current code-library by flashing its [TAPE], [VCR], and [MACRO] keys. For example, to indicate code-library #501 the HTR 2 will flash [TAPE] 5 times, pause, and then flash [MACRO] once. You might wish to make a note of your components’ code-library numbers.

SUMMARY OF HTR 2 MODES

Mode	Keys To Press (for 3 seconds)
Learn/Copy/Punch Through	Device Key + Record Key
Delete Mode	Device Key + Return Key
Macro Record	Macro Key + Function Key
Library Mode	Device Key + Preset Key
Back Light Timeout	Display Key + Digit Key
Factory Reset	(see “Factory Reset,” above)

TRIGGER SETUP

The T 743’s rear-panel TRIGGER output can be assigned to any of its six AV inputs: DVD, SAT, VCR, VIDEO 4-6. Whenever the assigned input is selected, either manually or by recalling a Preset, the TRIGGER output will produce +12 V DC, which can be used to activate a connected component or system. See your NAD audio specialist for more information.

ASSIGNING THE TRIGGER OUTPUT

From the OSD’s main <Setup> menu, select the <Input Settings> item using the remote's [ / ] and [ / ] keys. One can select the video input (DVD, SAT, VCR, or VIDEO 4-6) you wish to assign to the TRIGGER 1 output. Select <Save and Exit> to store the trigger assignment.

ENGLISH

29