Binding Cables
Secure the HDMI cable, DisplayPort cable, and USB cable using the cable clamp.
1. Remove the cable clamp. | 2. Route the cables through the cable | 3. Push the cable clamp down into place. |
| restraint slot. |
|
Cable restraint slot
Cable clamp | Cable clamp |
Caution
•When connecting cables, spread a soft cloth on a stable level surface such as a desk, and gently place the monitor on it with the screen facing down.
Connecting Peripheral Equipment
Caution
•Be sure to turn off the power and disconnect the plug from the power outlet before connecting/disconnecting cables. Also, read the manual of the equipment to be connected.
•Do not forcibly bend or apply force to cables. Doing so may result in wire breakage or other damage.
•When connecting cables, spread a soft cloth on a stable level surface such as a desk, and gently place the monitor on it with the screen facing down.
•Do not use any cable that has a damaged or deformed terminal. Using such cables may cause malfunctions.
TIPS
•Images may not be displayed properly depending on the computer (video card) to be connected.
Connection with a PC
Connect the monitor and a PC using the connection cable.
nInputting video and audio
HDMI input terminal
Commercially available HDMI cable (conforming to the HDMI standard)
To HDMI output terminal on PC
HDMI input terminal
Check the orientation of the connector and insert it horizontally as far as it will go.
•It is possible to connect the monitor’s HDMI input terminal to a smartphone or similar
This production incorporates MHL 1.
DisplayPort input terminal
Commercially available DisplayPort cable
To DisplayPort output terminal on PC
DisplayPort input terminal
Check the orientation of the connector and insert it horizontally as far as it will go.
TIPS
•The length of the signal cables or surrounding environment may affect the image quality.
•The video from the terminal that has signal input is displayed. In this state, even if a signal is input from the other terminal, the display is not switched. To switch the display, use [Input Select] on the menu screen. (See page 18.)
•If the LCD monitor is turned on when there are input signals from both terminals, the video from the DisplayPort input terminal is displayed.
9 E