Vidikron 20ET owner manual Turning off the Power

Page 34

Turning off the Power

■Press the OFF key on the remote control to turn off the unit.

■The POWER LED will blink green and the fans will speed up for a quick cool down. The projector will not respond to any command for 90 seconds.

■The POWER LED will light solid orange once the cooling down cycle has completed.

■Fans will run for three minutes to cool.

■You may turn the projector back on after the first 90 seconds.

Basic Operation

English

33

Image 34

Contents Vision Model Vision Model 20ET Table of Contents Connecting Video Inputs Using the Menu Main Menu Picture Quality AdjustmentsImage Option Projector Status Install Service Image OptionsRisk of Electric Shock English Two Year Limited Warranty RIGHTS, Limits and Exclusions Features OverviewPIP/ PBP function Video MemoryFront Lamp Cover Projector Exterior ViewFront / Upper Side Control PanelRear / Bottom Side Controls and Functions Control PanelZoom Ring Arrow c/e/d/fFocus Ring Connector Panel Remote Control Arrow c,e,d,fPIP Picture in Picture Wide IntelliWidePOP Picture On Picture Installation Remote ControlAdjust the Lens Zoom/Focus ring Connect the Power CordProjector Adjust the height Installation For Vision Model 20 With 1.71 2.06 Lens CeilingThrow Distance Chart For Vision Model 20 With 1.71 2.06 Lens Screen Hight Screen Width Min TD Max TD Vertical OffsetInstallation For Vision Model 20ET With 2.31 3.06 Lens CeilingSWx2.31 SWx3.06 Screen Width x Connecting Video / S-Video / Component Interlaced Video Connecting Video InputsDVD Player Progressive Component DTV Y/PB/PR DTV SourceRgbhv DTV RGB English Turning on the Power Basic OperationZoom/ Focusing Selecting Video MemorySetting Menu Selecting Input SourceSelecting Aspect Ratio PIP/ POP functionTurning off the Power Using the Menu MenuProjector Status Install Service Picture Quality AdjustmentsPicture Adjust Main MenuImage Options Input SelectAspect Ratio ScreensImage Option Memory StoreInstall Service Picture Adjust Image OptionsProjector Status English Francais Espanol Deutsch Italiano Picture ConfigurationFloor Front Ceiling Front Floor Rear Ceiling Rear Lamp Reset Timer ServiceBlue Enable White BalanceReset Lamp Timer Blue EnableWhite Balance Blue Enable Additional Information Replace the Lamp Contact your Vidikron DealerTroubleshooting This unit does not turnNo picture Remote control doesPower LED blinks Image is unstableSpecifications Vision Model 20/ Vision Model 20ET SpecificationsAnsi Lumen specification Dimensions RS-232 Setup RS-232C Control CodesPC Out Adapter Sub 9-pin female