AMD 4118 specifications Creating a Security Array With An Existing Data Drive

7ZXR Motherboard

Creating a Security Array With An Existing Data Drive

NOTE: This motherboard permits only two drives to be used for a single Mirrored array in Auto Setup.

You would use this method if you wish to use a drive that already contains data and/or is the bootable system drive in your system. You will need another drive of identical or larger storage capacity.

WARNING: Backup any necessary data before proceeding. Failure to follow this accepted PC practice could result in data loss.

WARNING: If you wish to include your current bootable drive using the Windows NT 4.x or Windows 2000 operating system as part of a bootable Mirrored (RAID 1) array on your system, do NOT connect the hard drive to the motherboard controller yet. You MUST install the Windows NT4 or 2000 driver

software first (see Raid Manual of the TUCD) to this drive while it is still attached to your existing hard drive controller. For all other Operating Systems, proceed here.

Follow these steps:

1.Using the Spacebar, choose “Security” under the Optimize Array for section.

2.Press <Ctrl-Y> keys to Save your selection. The window below will appear.

Do you want the disk image to be duplicated to another? (Yes/No)

Y - Create and Duplicate

N - Create Only

3.Press “Y” for the Create and Duplicate option. The window below will appear asking you to select the Source drive to use. FastBuild will copy all data from the Source drive to the Target drive.

		Source Disk
Channel:ID		Drive Model	Capacity (MB)
		Target Disk
Channel:ID		Drive Model	Capacity (MB)
		[Please Select A Source Disk]
Channel:ID		Drive Model	Capacity (MB)
1 :Master	QUANTUMCR8.4A		8063
2 :Master	QUANTUMCR8.4A		8063
		[↑ ] Up [↓ ] [ESC] Exit	[Ctrl-Y] Save
		51