
2.7EXTERNAL 3.5” DEVICE INSTALLATION
There is one external 3.5” drive bay.
1.Carefully remove the plastic drive bay cover and metal plate covering the drive bay.
2.Find a pair of 3.5”drive rails in the included hardware kit box.
3.Mount the drive rails onto the sides of the 3.5” device. Make sure the metal portion is angled on the outside and facing forward.
4.Slide the device into the drive bay until it clicks into place.
5.Connect a small
2.8EXTERNAL 5.25” DEVICE INSTALLATION
There are four 5.25” drive bays that need a total of eight drive rails.
1.Carefully remove the drive bay cover/filter assembly by pressing the two tabs inward, then remove the metal plate covering the drive bay.
2.Mount the drive rails onto the sides of the 5.25” device. Make sure the metal tab is angled away from the drive.
3.Slide the device into the drive bay until it clicks into place.
4.Mount the other devices accordingly.
5.Connect the appropriate Molex or SATA connector from the PSU to the power connector on each of the devices.
7