Note: Please check your motherboard manual for your USB header pin layout and make sure it matches the table below.
|
|
| Motherboard Pin Layout |
| ||
1 | 2 |
|
|
|
| |
Pin | Signal Names | Pin | Signal Names | |||
|
| |||||
|
| 1 | USB Power 1 | 2 | USB Power 2 | |
|
|
|
|
|
| |
|
| 3 | Negative Signal 1 | 4 | Negative Signal 2 | |
|
|
|
|
|
| |
|
| 5 | Positive Signal 1 | 6 | Positive Signal 2 | |
|
|
|
|
|
| |
|
| 7 | Ground 1 | 8 | Ground 2 | |
|
|
|
|
|
| |
9 | 10 | 9 | Key (No Connection) | 10 | Empty Pin | |
Connecting the eSATA Port
This case comes with an eSATA port in the front of the case to connect to your external SATA devices. You will find a SATA connector on a cable attached to the front eSATA ports. Connect it to a SATA connector on your motherboard.
Connecting the Audio Ports (AC’97 and HDA)
There is an Intel standard
106 4 2
9 7 5 3 1
Pin Assignment for Audio Ports (HDA and AC’97)
Pin | Signal Names | Pin | Signal Names | |
(HDA) | (AC’97) | |||
|
| |||
1 | MIC2 L | 1 | MIC In | |
|
|
|
| |
2 | AGND | 2 | GND | |
|
|
|
| |
3 | MIC2 R | 3 | MIC Power | |
|
|
|
| |
4 | AVCC | 4 | NC | |
|
|
|
| |
5 | 5 | Line Out (R) | ||
|
|
|
| |
6 | MIC2_JD | 6 | Line Out (R) | |
|
|
|
| |
7 | F_IO_SEN | 7 | NC | |
|
|
|
| |
8 | Key (no pin) | 8 | Key (no pin) | |
|
|
|
| |
9 | 9 | Line Out (L) | ||
10 | LINE2_JD | 10 | Line Out (L) |
Note: Please check your motherboard manual for your audio header pin layout and make sure it matches the table. Even if your system supports both audio standards, you may only connect one connector, not both.
Installing the Drives
With the front bezel facing you, swing the front door out. It can swing 270 degrees so the door will be parallel with the side of the case. You can see one 5.25” external drive bay at the top and two 5.25” drive bays at the bottom of the
3