Aiphone KBW-M manual Kbw-M, Instructions, Special Order Products

Special

Order

Products

KBW-M

Video Modulator for the KB Series Color Video System

- INSTRUCTIONS -

The KBW-M adaptor converts a standard CCTV camera's signal to a 2-wire signal, compatible with the KB 3x5 Color Video system. This allows the utilization of a color camera on a video input on the KB system, viewable from any monitor in the system. (A camera and KBW-M can be added to any input that is not used by a KB-DAR video door station.)

KBW-M	Camera
Output to	input
KB-3MRD

Input from Motion

Detector

KBW-M TERMINAL DEFINITIONS:

BNC Connector: Coax input from CCTV camera

A1	2-Wire output to
A2	KB-3MRD
MD	Input from motion detector
MD	(with normally open contacts)

WIRING DIAGRAM: KBW-M Modulator for Standard CCTV camera

KB-DAR				KB-3MRD
A1			Non-Polarized	1A1
A2	KB-DAR			1A2
	A1		Non-Polarized	2A1
	A2			2A2
		KBW-M
		A1	Non-Polarized	3A1
		A2		3A2
CCTV Camera
75 Ohm, 1V Peak-to-peak
(Independently powered)		BNC
				B1
		Cnctr
	Motion Detector*		PS-2420UL	B2
		MD		+
			+
		MD		-
			-

(Optional)

NOTES:

1.In this system example, the CCTV camera is on input #3. Cameras are viewed by pressing the MONITOR button (on any monitor.) Press once to turn on camera 1 (KB-DAR), press again to switch to camera 2 (KB-DAR #2). Pressing MONITOR a third time will switch to Camera 3 (CCTV), and a fourth time turns the monitor off.

2.OPTIONAL: An input for a motion detector is provided to activate the CCTV camera. The Monitor will turn on and a chime will be heard. The monitor will stay on for approximately 30 seconds.

* Or any signaling	Motion Detectors with N/O Contacts:
device that provides a	Detection Systems DS720I
normally open	Pulnix 6612
momentary dry closure.	Intellisense 8140S
	Ademco 1998PI
	Sentrol AP750	Pg. 1