AMX RE-DM4 Low-Voltage Connections, Setting AXLink Address Numbers, Connecting AXLink

Low-Voltage Connections

The low-voltage area in the AMX Lighting controllers contain connections and DIP switches for AXLink, dry closures, and RDM module connectors. On the controller cards, low-voltage power for the board is supplied either by line power, optional auxiliary power supply (RDA-PSM), or the +12 VDC pin on the AXLink connector.

AXLink address DIP switch	Module connector/LED (CH6)
	Module connector/LED (CH5)

Each dry contact closure has two pins: ground and contact. To activate each dry closure, connect the ground and contact.

Setting AXLink Address Numbers

Set the AXLink address number (1-255) for the RE-DM4. This number must match the device number in your Axcess program.

Note: By turning all switches off, all circuits will go to 100 percent so that the installer can test the high-voltage connections without having connections to a control system.

Connecting AXLink

Connect the 4-pin captive-wire AXLink from the RE-DM4 to the Central Controller for AXLink control of the dimming system.

AXlink connector Dry contact closures Auxiliary power IN

FIG. 4 Low-voltage connections and DIP switches

WARNING: Disconnect the main power to the AMX Lighting controller at the breaker box if rewiring the low voltage connections.

Dry Closure Connections

Dry contact closures from other equipment can be connected to the Radia Eclipse dimmer module to provide direct manual control of lighting loads (FIG. 5).

		FAILSAFE	Failsafe switch
		GND
RE-DM4	EMERGENCY		Alarm system
		GND

	PWR
RE-DM4	AXP
	AXM
	GND

FIG. 6 Connecting AXlink

RE-DM4 4-pin module connector (male)

Pin 4 (GND)

Pin 3 (RLY)

Pin 2 (DIM)

Pin 1 (+12 V)

PWR AXP AXM GND

Central Controller

FIG. 5 Dry Closure Connections

FIG. 7 RE-DM4 module connector

Lighting Application Drawings

Example A Single input

120 or 240 VAC 1Ø

Single-phase, four load

FIG. 8 Example A

Example B

Dual Input

120, 120/240, or 240 VAC 1Ø Single-phase, four load

FIG. 9 Example B

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). 93-0706-01 REV: C

8/07

©2007 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com