AMX AV2SM instruction manual Installation, Automatic and Manual Switching Mode Settings

Page 7

Installation

Installation

You can install the AV2SM on any flat surface that has unobstructed access to both the front and rear panel connectors.

Automatic and Manual Switching Mode Settings

You can select the switching mode by setting two internal jumpers on the circuit card inside the enclosure. You will need a Phillips screwdriver to open the enclosure. To set the switching mode:

1.Discharge the static electricity from your body and screwdriver.

2.Unplug all connectors from the front and rear panel of the AV2SM.

3.Turn the enclosure upside down and remove the two Phillips-head screws.

4.Pull the enclosure apart and turn the bottom half, containing the circuit card, right-side up.

5.Choose the desired switching mode:

!For automatic mode (FIG. 2), place the 2-pin jumper on the E1 connector pin’s one and two. Repeat for the E2 connector.

E2 E1

AUTO

AUTO

MAN.

FIG. 2 Automatic mode settings

!For manual mode (FIG. 3), place the 2-pin jumper on the E1 connector pin’s 2 and 3. Repeat for the E2 connector.

E2 E1

AUTO

MAN..

FIG. 3 Manual mode settings

AV2SM A/V Switcher

3

 

 

 

 

Image 7
Contents AV2SM AMX Limited Warranty and Disclaimer Table of Contents Table of Contents Product Information SpecificationsRear Panel Automatic and Manual Switching Mode Settings InstallationWiring Guidelines Wiring GuidelinesAudio output connector Select Elect Installation AV2SM A/V Switcher AMX reserves