D-Link DFE-908X manual Connectivity Rules

Page 30

Hubs should not be added to the stack or removed from the stack while the

power is on to any hub in the stack. Always turn off power to the entire stack before adding or removing hubs.

Connectivity Rules

Ethernet (10Mbps) networks need to respect the following connectivity rules:

18

Making Connections

Image 30
Contents Recyclable Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Trademarks Vcci B Warning Vii Page Table of Contents Cables and Connectors About this Guide ConventionsOverview of the User’s Guide About this Guide Introduction Product DescriptionProduct Features Dual-speed Fast Ethernet/Ethernet Hub Technology Overview 10Mbps Repeater 100Mbps Repeater NWay Detection RJ-45 Ports Cables and Connectors 100BASE-TX Technology Overview100Mbps Fast Ethernet Introduction Topology Network DiameterUnpacking Setup Hub TypesUnpacking Identifying External ComponentsFront Panel LED Indicator Panel Twisted-Pair PortsUplink Port Daisy-Chain in Port AC Power Connector For the power cordRear Panel Daisy-Chain OUT PortInstalling the Hub InstallationUnderstanding Indicators Hub State IndicatorsPower Indicator PWR 10Mbps and 100Mbps Utilization Indicators Port State IndicatorsCollision Indicators Col 10M/ Col 100M Link steady greenReceive Rx blinking green Port Speed IndicatorsSwitch Indicator DFE-908x Only Auto-partition Auto-part steady amberPage Page Making Connections Hub Cascading/Building a StackConnectivity Rules Hub to End-Station Connection Making Connections Hub-to-Hub Uplink HUB Device Port Cable to USE Type Used Cables Connectors 100BASE-TX Ethernet Cable and ConnectorsContact MDI-X Signal MDI Signal Crossover CablesDual-Speed Stackable Hubs User’s Guide Cables and Connectors Hub-to-Hub Cascading SpecificationsGeneral Topology StarOperating Temperature -10to 55C 14-131F LED IndicatorsPower Supply Environmental and PhysicalPage Offices Page Registration Card