D-Link DES-810, DES-818 manual Network Configuration Examples, Setting the Duplex Mode

Page 28

switch up. To set for half-duplex, set the duplex switch down. To set either or both ports 1 and 2 to auto duplex mode detect, set the corresponding switch down.

Figure 6 Setting the Duplex Mode

Note:	Full-duplex	mode	can	only be	used for
	connections	to	other	switches,	network
	servers, or network stations.

Connections to hubs must use half-duplex mode only.

Network Configuration Examples

This section provides sample configurations showing ways you might use the 10/100 Fast Ethernet Switch.

18	Installation

Image 28

Contents DES-810 DES-818 10/100 Fast Ethernet Switch User’s Guide Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Link Offices to Contact for Warranty Service Trademarks Table of Contents Specifications Connector Pinouts Preface Usage/ScopePurpose AudienceInstallation Manual OrganizationOverview Introduction100Mbps Fast Ethernet Introduction Cables and Connectors100BASE-TX Technology Overview Topology NetworkHubs Connectivity RulesSwitching Technology Benefits of SwitchingProduct Features 10/100 Switching TechnologyPacking List Front Panel Ports10/100Mbps Ports LED Indicators Uplink Port∙ Power LED Rear PanelDuplex Mode Switch Installation Installation SiteInstalling on a Desktop or Shelf Installing the 10/100 Fast Ethernet Switch on a TableNetwork Connections Connecting Power10/100Mbps Ports 10Mbps Ports Cable TypesSetting the Duplex Mode Using Straight-Through and Crossover CablesNetwork Configuration Examples Setting the Duplex ModeLAN Microsegmentation Fast Ethernet Server ConnectionFast Ethernet Connection for a Server Specifications Specifications Connector Pinouts RJ-45 ConnectorsFigure B-2 Crossover Cable Offices Registration Card