D-Link DES-2212 manual Snmp Information and Console Timeout, Software Update Menu

Page 47

User’s Guide

♦Boot Server IP Address The IP address of the TFTP server where the configuration file is located. This entry is used only if the S/W Update Control is enabled and your boot protocol is tftp only; if you are using bootp-tftpmode, or if Send BOOTP Request on Power Up is enabled, the address will be obtained from the BOOTP server.

♦Boot File Name The pathname of the configuration file on your TFTP server. If you are using D-View as your TFTP server, this is the pathname of the .CFG file on your hard disk. This entry is used only if your boot protocol is TFTP ONLY; if you are using BOOTP&TFTP mode, or if Use Bootp to get IP after start up is enabled, the pathname will be obtained from the BOOTP server.

For more information about DES-2212 configuration files, consult the appendix. For detailed information about using the TFTP and BOOTP servers, consult the D-View User’s Guide .

Figure 6-12. Software Update Menu

SNMP Information and Console Timeout

The System Configuration Menu screen shows various pieces of information about your switch, and allows you to set the System Name, System Location, and System Contact. These settings can be retrieved from the switch using

Using the Console Interface

35

Image 47

Contents Recyclable Wichtige Sicherheitshinweise Warranties Exclusive Limited Warranty Software Trademarks Table of Contents Making Network Connections Product Specifications Page About this Guide Page Ports DES-2212 Ethernet/Fast Ethernet SwitchIntroduction Management Switching100BASE-TX Technology Overview Cables and Connectors100Mbps Fast Ethernet Introduction Network TopologyConnectivity Rules HubsEthernet Switching Introduction Front Panel External FeaturesExternal Features LED Indicators Rear Panel External Features Page Unpacking the Switch InstallationRack Mounting Installing the SwitchLocation Connecting Power Replacing the Fuse 10BASE-T Connection Making Network Connections100BASE-T Connection MII Connection Making Network Connections Connecting to the Switch Using the Console InterfaceConsole Usage Conventions First Time Connecting To The Switch Steps to create a Super User or General User Super and General User PrivilegesMain Menu for General User Super User and General User Privileges Login On The Switch Console By Registered Users Choose Change Password Changing your PasswordAdding a New User Adding and Deleting UsersDeleting a User TCP/IP Settings Setting up the SwitchUsing the Console Interface 10. TCP/IP Parameters Configuration Menu Out-of-band management and console settings11. Out-of-Band/Console Setting Menu Software Updates12. Software Update Menu Snmp Information and Console Timeout13. System Configuration Menu Snmp Traps 14. Snmp Trap Manager Configuration MenuSnmp Security Community Names Switch ConfigurationControlling Individual Ports 16. Port Configuration Menu17. STA, Forwarding Table Forwarding ConfigurationUsing the Console Interface Spanning Tree Protocol and Configuration Introduction to Spanning Tree Protocol Parameters Using the Console Interface Setting Spanning Tree Protocol Parameters Using the Console Interface Using the Console Interface Using the Console Interface Displaying Port Statistics Monitoring the SwitchUsing the Console Interface System Reset Resetting the SwitchFactory Reset Using the Console Interface Page General Product SpecificationsEnvironmental and Physical 10BASE-T/100BASE-TX Connectors Cables ConnectorsStraight-through Cable Crossover Cable MII ConnectorMII Connector Pin Assignment E , D B RS-232 DB9 Pin SpecificationE , D B -2 R 2 Page Sysdescr string Boot Configuration FileSyslocation string Clear-SNMP-comm-table Index IndexSnmp Page Offices Page Registration Card