Allied Telesis AT-9800 Series manual CR00007521 Module IPGLevel, CR00007686 Module ATM Level

Release sb273-01 5

CR00007521 Module: IPGLevel: 3

DVMRP packets were being dropped due to packet length inconsistencies from other vendor devices.

This issue has been resolved. (No PCR number.)

CR00007686 Module: ATM Level: 3

If ATM is receiving a OAM loopback cell (normal from an ISP) at regular intervals then it may cause a reboot. This fix stops this behaviour and will also stop some other random packet corruption.

This issue has been resolved. (PCR number: 50064)

CR00007716 Module: LOG Level: 3

Previously, when changing the password on a log output/receive definition to a shorter string, the log message exchange could fail.

This issue has been resolved. (PCR number: 50070)

CR00007760 Module: SWCX, SWITCH Level: 3

When changing VLAN configuration on the Switchblade, MAC addresses on the ports that move to a new VLAN need to be deleted. This address deletion process has been made significantly more efficient, minimising the impact on general switch operation.

This issue has been resolved. (No PCR number.)

Level 4

CR00006093 Module: FFS Level: 4

There was not enough information displayed to the user when the ACTIVATE FLASH COMPACTION command was entered at the same time as Flash was compacting.

This issue has been resolved. (No PCR number.)

Enhancements

CR00006652 Module: IKMP, IPSEC

Previously ISAKMP NAT-T was enabled by default on every ISAKMP policy created. NAT-T is now disabled by default on every ISAKMP policy. (No PCR number.)

CR00006953 Module: PPP

The ability to configure Van Jacobson Header Compression over dynamic

PPPinterfaces has been added. To this end, the command parameter 'VJC={ONOFF}' has been added to the CREATE and SET PPP TEMPLATE commands. (No PCR number.)

Release sb273-01 C613-10436-00 Rev A