APC AR8163ABLK, AR8173BLK, AR8182BLK, AR8184, AR8162ABLK manual Installing Data Cable Partitions

Installing Data Cable Partitions

Use the procedure in this section to install all of the Data Cable Partitions. You can install Data Cable Partitions on a NetShelter Enclosure or a PDU.

1.Squeeze the two sides of the Pass-through Data Cable Partition to insert the fastening tabs into a set of square holes.

ns1299b

2.Determine the width that will be required for data cable routing, then install the Data Cable Partition at the front of the roof with a solid side in the same manner as step 1.

Note: Use a Data Cable Partition with a solid side at the front of the enclosure to ensure a finished appearance.

ns1300b

2 Data Cable Partitions—Installation