Linksys SR2024C manual Placement Options, Wall-mount

Page 12

16-Port or 24-Port 10/100/1000 Gigabit Switch

Placement Options

There are three ways to physically install the Switch: set the Switch on its four rubber feet, mount the Switch in a standard-sized, 1U high rack, or hang the Switch on a wall using its wall-mount slots.

To rack mount the Switch, follow these instructions:

1.The Switch has four mounting holes on each side. Screw an included mounting bracket into each side.

2.Place the Switch in the rack, and secure the brackets with additional screws.

To hang the Switch on a wall, follow these instructions:

1.The wall-mount slots are two crisscross slots on the Switch’s bottom panel (see Figure 3-3). The distance between the two slots is 95 mm. Attach two screws to the wall, so that the Switch’s wall-mount slots line up with the two screws.

2.Maneuver the Switch so the screws are inserted into the two slots.

Congratulations!The installation of the Switch is complete.

Chapter 3: Connecting the Switch

Figure 3-3: Wall-mount

8

Placement Options

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 16 or 24-Port 10/100/1000 Copyright and Trademarks Table of Contents SR2016 Front Panel SR2024C Front PanelIntroduction WelcomeWhat’s in this Guide? Getting to Know the Switch Front PanelSR2024C Side Panel Security SlotConnecting the Switch OverviewConnection Instructions Maximum Cabling DistancesPlacement Options Wall-mountAppendix a Glossary Port or 24-Port 10/100/1000 Gigabit Switch Port or 24-Port 10/100/1000 Gigabit Switch Port or 24-Port 10/100/1000 Gigabit Switch Port or 24-Port 10/100/1000 Gigabit Switch Appendix B Specifications Appendix C Warranty Information Limited WarrantyAppendix D Regulatory Information FCC StatementPort or 24-Port 10/100/1000 Gigabit Switch Port or 24-Port 10/100/1000 Gigabit Switch Port or 24-Port 10/100/1000 Gigabit Switch Port or 24-Port 10/100/1000 Gigabit Switch Port or 24-Port 10/100/1000 Gigabit Switch Appendix E Contact Information
Top Page Image Contents