Chapter 3: Connecting the 10/100
SwitchPlanning Your Network Layout
Overview
This chapter will explain how to connect network devices to the Switch. For an example of a typical network configuration, see the application diagram shown in Figure
Figure
When you connect your network devices, make sure you don’t exceed the max- imum cabling distances, which are listed in the following table:
Maximum Cabling Distances
From | To | Maximum Distance |
Switch | Switch or Hub* | 100 meters (328 feet) 1 |
|
|
|
Hub | Hub | 5 meters (16.4 feet) 1 |
|
|
|
Switch or Hub | Computer | 100 meters (328 feet) 1 |
|
|
|
*A hub refers to any type of 100Mbps hub, including regular hubs and stackable hubs. A 10Mbps hub connected to another 10Mbps hub can span up to 100 meters (328 feet).
Connecting Network Devices
To connect network devices to the Switch, follow these instructions. (The 16- Port 10/100 Switch is shown in Figure
1.Make sure all the devices you will connect to the Switch are powered off.
2.Connect a Category 5 Ethernet network cable to one of the numbered ports on the Switch.
Figure
3.Connect the other end to a PC or other network device.
4.Repeat steps 2 and 3 to connect additional devices.
5.Connect the supplied power cord to the power port on the Switch’s back panel.
6.Plug the other end of the power cord into an electrical outlet.
7.Power on the devices connected to the Switch. Each active port’s corre- sponding LED will light up on the Switch.
Proceed to the following section, “Placement Options.”
4 | 5 |