Accton Technology 3008P Port and Cable Assignments, Power and Cooling Problems, Installation

Page 14

Quick Installation Guide

Power and Cooling Problems

If the Power indicator does not turn on when the power cord is plugged in, you may have a problem with the power outlet, power cord, or internal power supply as explained in the previous section. However, if the unit powers off after running for a while, check for loose power connections, power losses or surges at the power outlet, and verify that the fan on back of the unit is unobstructed and running prior to shutdown. If you still cannot isolate the problem, then the internal power supply may be defective. In this case, contact your Accton distributor for assistance.

Cabling and Adapters

If the Link indicator fails to light when you connect a device to the hub, check the following items:

Be sure the twisted-pair cable is properly attached to the connected device and the hub. Verify that the media connector snaps into place when attached.

See if your cable is functioning properly by using it for another port and attached device that displays valid indications when connected to the network.

Check the length of each twisted-pair cable to be sure it does not exceed 100 meters (328 feet). If you have cascaded two Fast Ethernet hubs together, be sure the interhub cabling is no longer than 5 meters (16 feet).

Verify that the workstation's adapter card is functioning properly by trying it in another computer that has been successfully connected to the network.

Installation

Verify that all system components have been properly installed. If one or more components appear to be malfunctioning (e.g., the power cord or network cabling), test them in an alternate environment where you are sure that all the other components are functioning properly.

Port and Cable Assignments

RJ-45 Port Description

RJ-45 (MDI-X) station ports can be attached to any devices which use a standard network interface (e.g., a workstation, server, bridge or router). RJ-45 (MDI) daisy-chain ports can be cascaded to a station port on similar networking devices (e.g., another hub or switch). Use unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable for RJ-45 connections: 100Ω Category 3, 4 or 5 cable for 10 Mbps connections or 100Ω Category 5 cable for 100 Mbps connections. Also be sure that the length of any twisted-pair connection does not exceed 100 meters (328 feet).

9

Image 14
Contents CheetaHub Power-3008P/3016P Quick Installation Guide CheetaHub Power-3008P/16P International Headquarters USA Headquarters Contents Page Introduction Installing the HubPackage Contents Description of HardwareCheetaHub Power-3008P/3016P Mounting the HubConnecting the Hub System Making a Connection via an RJ-45 Station PortMaking a Connection via an MDI Daisy-Chain Port Powering On the Hub Verifying Port StatusVerifying System Operation ApplicationsProduct Specifications Repeater CriteriaDiagnosing Hub Indicators TroubleshootingInternal Switching Criteria Port and Cable Assignments Power and Cooling ProblemsInstallation Cabling and AdaptersClass a Canada Department of Communications EMI CertificationFCC Class a USA Safety Compliance Underwriters Laboratories Inc. USAVoltage Cord Set Specifications Wichtige Sicherheitshinweise GermanyWarranty EH3008P