When you have linked the modules, they can talk with each other up to 20 feet apart.
NOTE: When you are not using the printer, terminal, and RF link device, be sure to turn them off.
S c a n n i n g B a r C o d e s
To scan a bar code:
1 . Point the scanner at a slight angle approximately 4 – 8 inches from the bar code symbol.
2 . Pull the trigger until you hear a beep, which indicates a complete scan. If you let go of the trigger before the beep, the scan stops immediately.
CAUTION: Do Not stare into the beam.
If the bar code does not scan:
♦Change the angle of the scanner slightly and try again.
♦Clean the scanner window.
♦Move the scanner 4 – 8 inches away from the bar code. Adjust this distance as needed to find the correct distance.
♦Try scanning another bar code that you have scanned successfully. If that scan is successful, the scanning problem is with the bar code.
♦Move to a more dimly lit area.
♦Be sure there are no voids in the bar code symbol.
4 Operating Instructions