Paxar 6017 manual E a N I N G

Page 19

C L E A N I N G	4

You may need to clean the printhead and platen roller after printing approximately six rolls of supply, whenever you load new supplies, or when you see voids in the print as shown.

CAUTION

Do not use sharp objects to clean the

printhead. This may damage the printer and require a service charge.

1.Open the supply cover by inserting your fingers into the rubber pull tab and pulling up firmly on the supply cover.

2.Remove the supply roll (when cleaning the printhead).

3.Moisten a cotton swab with isopropyl alcohol and clean the printhead as shown.

Printhead

Cleaning 4-1

Image 19

Contents Monarch 6017 HandiPrint Printer Canadian D.O.C. Warning Getting Started B L E O F C O N T E N T SPage P a c k i n g t h e P r i n t e r T T I N G S T a R T E DO g r a m m i n g I n f o r m a t i o n T t e r y a n d S a f e t y I n f o r m a t i o n Install i n g t h e B a t t e r yOpen the battery door A r g i n g t h e B a t t e r y Getting Started Reading the LED N n e c t i n g t h e P r i n t e r 8Getting Started A D I N G S U P P L I E S A r i n g S u p p l y I n g t h e M a g n e t i c S t r i p e R e a d e r I n t i n gGreen LED on the printer indicates the following Scanner Information A n n i n g B a r codesScanning Tips E a N I N G 2Cleaning Troubleshooting Programmers Manual for more I n t e r Specification s Specification ST i o n s P p l y Specification sUsing the Optional Stand For Wall-Mounting Page U.S.A 021 869 97 70 In Switzerland