Quick Reference

Switching Between Print Modes—Peel Mode or Non-peel Mode

1.Press the Pizza Hut® button on your keypad/terminal.

2.Press the Cheese button to display “NON-PEEL MODE” or “PEEL MODE” until the print mode you want is displayed.

3.Press the Pizza Hut® button to save your choice.

4.The printer LED will blink red. Press the printer FEED button. The printer LED will turn green, indicating the printer is ready. Default mode is non-peel.

Loading Labels for Hot-Hold (Peel) Labeling

Follow these instructions to print and peel labels from the backing paper one at a time.

Supply Holder

Guides

Peel Door	Peel Roller	Peel Bar

1.Press the cover release levers towards you to release the cover and then lift it open.

2.Pull out the peel door located on the front of the printer to display the peel roller and the peel bar.

3.Remove a supply holder guide from one end of the supply holder.

4.Slide a roll of labels onto the supply holder.

5.Place the supply holder guide back onto the end of the supply holder.

Label Roll Mount

Push the label core adapters into the ends of the supply and center the labels on the supply holder. The number 4 (on the supply holder) should be visible on either side of the supply holder guides.

6.Place the loaded supply holder in the slots in the label roll mount. Push the plastic line attached to the end of the supply holder out of the way.

7.Remove the first two labels from the

backing paper.

8.	Feed the labels, printing side up, under the
	supply guides and over the platen roller.
9.	Feed the backing paper under the peel	Peel Roller	Peel Door Opening
	roller and through the peel door opening.


TC941XQR Rev. AA 3/04		©2004 Paxar Americas, Inc. All rights reserved.