C H A R G I N G T H E B A T T E R I E S | 3 |
This chapter describes how to
ucharge the Mobile Work Station’s batteries
uchange the fuses.
The battery charger is a fully automatic,
Make sure the voltage selector switch (located on the back of the charger) is set for the proper voltage (115V or 220V). Dispose of used batteries according to the manufacturer’s instructions.
To charge the battery, plug the Mobile Work Station’s AC power cord into a grounded outlet. Charge the battery:
ubefore using the MWS for the first time (charge it for 7 hours)
uwhen the MWS beeps (see “Battery Life” for indications of low battery conditions)
uwhen the MWS is not in use.
When the MWS is not in use, always leave the battery charger plugged in and charging. The battery charger is “intelligent;” it monitors the battery condition and does not overcharge the lead acid battery. Battery life is extended by frequent charging.
CAUTION
Only qualified service personnel may install or replace the two
If replacing batteries, you must use the same type of battery from the same manufacturer (as the ones provided with the MWS). Make sure the batteries are
Charging the Batteries