Paxar Monarch 9805 manual A d i n g L a b e l s, Thermal Direct, Thermal Transfer

L o a d i n g L a b e l s

Thermal Direct	Supplies that do not require a ribbon for printing.
Thermal Transfer	Supplies require a ribbon for printing. Some
	models may not support thermal transfer printing.

If you are using thermal direct supplies, do not load a ribbon. Make sure the printer is configured for the correct supply type. If you experience supply feeding problems with 2.0-inch wide or less supplies, adjust the wide/narrow knobs to the wide setting. You may also need to use the wide setting in cold, dry environments.

1. Open the cover.

2. Unlock the printhead by turning the retaining latch.

3. Lift printhead assembly using the printhead tab until the assembly locks into place.

4. Center the roll of supply on the supply holder. Make sure the supply unrolls from the top as shown.

If you are using fan-fold
supplies, place the supply stack
behind the printer, label side facing
up.	Roll Supply

5.Push down on the supply lever to

unlock the supply guides.

6. Lay the label strip across the supply guide so that a few inches extend past the front of the printer. Tuck the supply under the nibs.

Supply Holder

Printhead Tab

Fan-Fold Supply

3