3Com 8 manual Important Safety Information

Page 27

IMPORTANT SAFETY INFORMATION

WARNING: Warnings contain directions that you must follow for your personal safety. Follow all directions carefully.

You must read the following safety information carefully before you install or remove the unit:

Exceptional care must be taken during installation and removal of the unit.

Only stack the OfficeConnect hub with other OfficeConnect units.

To ensure compliance with international safety standards, only use the power adapter that is supplied with the unit.

The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by disconnecting the power cord from the outlet.

This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 950. The conditions are only maintained if the equipment to which it is connected also operates under SELV conditions.

There are no user-replaceable fuses or user-serviceable parts inside the hub. If you have a physical problem with the unit that cannot be solved with problem solving actions in this guide, contact your supplier.

Disconnect the power adapter before moving the unit.

WARNING: RJ-45 ports. These are shielded RJ-45 data sockets. They cannot be used as telephone sockets. Only connect RJ-45 data connectors to these sockets.

27

Image 27
Contents OfficeConnect Ethernet Hub 4, 4C, 8, 8C 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Important Safety Information Wichtige Sicherheitshinweise Consignes importantes de sécurité Technical Support Introduction Transceiver Connections Creating Your NetworkWhat Else Do I Need? Workstation ConnectionsHub Connections 10BASE-2Twisted Pair TP Cables Stacking the Units Together Rubber FeetStacking Clip Using Your Hub Positioning Your HubSecuring Your Hub AUI/COAX Status LEDs Hub 4C only Officeconnect Ethernet HUB 4 and 4CEthernet Hub 4 and 4C-Front Network Utilization LEDs Hub 4C only10BASE-2 port Hub 4C only Ethernet Hub 4 and 4C-RearConnecting Workstations and Other Equipment to Your Hub Connecting OfficeConnect Ethernet Hubs TogetherConnecting Transceivers to the AUI Port Checking Connections Connecting Hubs Using 10BASE-2Spot Checks Connecting Hubs Using 10BASE-TProblem Solving for the HUB 4 and 4C Straight-through Cable/Crossover Cable Port Status LEDs Power LED Collision LEDOfficeconnect Ethernet HUB 8 and 8C Ethernet Hub 8 and 8C-FrontPower Adapter socket Uplink/Normal switch Ethernet Hub 8 and 8C-Rear10BASE-2 port Hub 8C only Connecting Workstations and Other Equipment to Your Hub 50 Ohm Terminator Switch set to Normal out Uplink Problem Solving for the HUB 8 and 8C Normal Pin Uplink Port Rx+ Tx+ Networking Terminology Standards Dimensions and StandardsDimensions and Operating Conditions Power WeightEnvironmental Statement about the Documentation Environmental StatementsEnd Of Life Statement Regulated Materials StatementImportant Safety Information Wichtige Sicherheitshinweise Consignes Importantes DE Sécurité World Wide Web Site Online Technical Services3Com Knowledgebase Web Services Technical SupportSupport from 3Com Support from Your Network SupplierCountry Telephone Number Asia, Pacific Rim EuropeEurope, South Africa, and Middle East North America Country Telephone Number Latin AmericaCountry Telephone Number Fax Number Returning Products for Repair3Com Corporation Limited Warranty Warranties Exclusive Disclaimer Electromagnetic Compatibility Wall mounting screw hole guide 150 mm 5.9 Part No. DUA 1670-0AAA04 Published June