Maxxsonics SS75.2, SS75.4 SS500.1 / SS7500.1 / Mono Amplifier Applications, Adaptor, Not Used

SS500.1 / SS7500.1 / MONO AMPLIFIER APPLICATIONS

Basic application

These sub bass amplifiers can be used in any of the bi-amplification systems described in this manual, replacing the 2 channel amplifiers as per the illustrations.

Interconnect cable checklist:

Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. Connect the LINE OUT to the inputs of the system highs amplifier.

Use at least #12 gauge speaker wiring. The amps have dual speaker terminals, simplifying the hookup of multiple speakers

Crossover frequency control checklist:

LOW PASS: 35Hz to 250Hz

autotek

PROTECT	POWER
0dB 18dB
ATR-1
	CONTROL	REMOTE
0dB 12dB	BOOST	BASS
15Hz 55Hz	SONIC	SUB
40Hz 150Hz	PASS	LOW
6V 0.2V	LEVEL
DESIGNATED MONO	L
R
OUTPUT FROM HEAD UNIT		OUTPUT
R		INPUT

SUBSONIC:15 Hz to 35 Hz

BASS EQ: 0 to +12dB

PHASE: 0 to 180 degrees

Level control checklist:

Refer to the section “Setting up systems after installation for best performance”

Minimum final loudspeaker impedance: 1-Ohm.

MONO

SUBWOOFER

SPEAKER OUTPUT	-
	+
	FUSE

REMGND +12V	OWEINPUT	TO BATTERY +12 Volts VIA FUSE
		REMOTE TURN-ON
		CHASSIS GROUND

FULL RANGE
STEREO LINE INPUT	Y-ADAPTOR

NOT USED

Note: You can use the Radio/CD designated mono line output

or a full range stereo line output. For full range stereo line output, you will need an optional “Y-Adaptor” as shown

SPEAKER OUTPUT

GND REM +12V

POWER INPUTFUSE+ + - -

PARALLEL MONO

SUBWOOFERS

2-OHMS EACH MINIMUM

8