Wireless N Dual Band Adapter | N900UBE | User Manual | |
|
|
|
|
Chapter 4 Ralink Utility Configuration
Ralink Utility enables N900UBE to serve as 3 modes: Wireless Client mode, Client + AP mode, and AP mode.
Wireless Client mode: This is the basic and default mode for N900UBE when you install the Utility. N900UBE will serve as a wireless dual band adapter at this mode.
Client + AP mode: N900UBE under this mode will serve as a wireless dual band adapter while broadcast signals that other
N900UBE can only transmit 2.4GHz signal if receives 2.4GHz signal from wireless router, and 5GHz signal if receives 5GHz signal from wireless router)
AP mode: N900UBE as AP will serve as a signal broadcaster while the computer it
installed in is connecting to internet via wire connection. (Note: N900UBE can only transmit either 2.4GHz signal or 5GHz signal in one time, but not at the same time)
4.1Wireless Client Mode
Wireless client Mode is the default access mode for N900UBE. N900UBE serves as a client to receive the wireless signal from the wireless router for connecting to the internet.
You can find this icon 
at the system tray and double click to start it on the lower right hand corner of your computer desktop. Or you can right click the tray icon and select Launch Config
Utility.
Once launched, you should see this window popup. Please refer to the later sessions for more detail introduction on Ralink Utility.
20