Port Switch’s Uplink Port | Rosewill RC-405X guide

10/100M Fast Ethernet Switch 5/8 port RC-405X/RC-406X			User Manual

5-port Switch’s Uplink Port

An uplink port is simply an Ethernet port where the Receive (Rx) and the Transmit (Tx) signals are swapped by crossing the Transmit and Receive twisted-pair wires.

This will let the Transmit signal (and twisted-pair) on RC-405X correctly connect to the Receive connection on the other device and vice-versa, allowing for stacking similar devices, or simply expanding the number of ports.

NOTE TO USERS OF 10/100 5-PORT SWITCH: If you connect a router or additional switch to the Uplink port, then you cannot use the numbered port next to the Uplink port (port 1X on the 5-Port Switch will be inactive). The two ports are wired together, so they cannot be used simultaneously.

yRear Panel

8-port

5/8-Port Switch indicates a DC (9V) inlet, which accepts 100-240V 50-60Hz power adapter.

Mounting 8 Port Switch On A Wall

The 8-port 10/100Mbps Switch can also be mounted on a wall. Four mounting slots are provided on the bottom of the switch for this purpose. Please make sure that the front panel is exposed in order to view the LEDs. Please refer to the illustration below:

1.Mounting on a cement wall

1.Mount the Nylon screw anchors into a cement wall.

2.Drive the T3x15L screws into the Nylon screw anchors

3.Hook the mounting holes of the switch back on the screws; you have completed the wall-mount

2.Mounting on a wood wall

1.Drive the T3x15L screws into the wood wall.

2.Hook the mounting holes of the switch back on the screws; you have completed the wall-mount

3.Note: For the minimum length of the screws

1.3/4 inch minimum for wood wall.

2.3 inch minimum for cement wall.

Thank you for purchasing a quality Rosewill Product.

Please register your product at: www.rosewill.com for complete warranty information and future support for your product.

Rosewill Customer Service: 1-800-575-9885 or at techsupport@rosewill.com